[ADC 1.0.2] Explicit note about responsibility in STA

Post by **Pretorian** » 22 Jul 2012, 15:26

STA does not explicitly define who should take action when a 'fatal' severity is sent. However, it makes only real sense that the sending/issuing party will manage any type of disconnect. That is, if the hub sends STA 231(perm ban) to a client, the hub isn't saying "you are permanently banned, please disconnect"; the hub must do the disconnecting.

So, I'd like to change the following to;

|2 |Fatal (disconnect), sending party is responsible for action.

Post by **Pirre** » 23 Jul 2012, 10:19

agree 100% , its going to take away a lot of confusion ...

Post by **Pirre** » 25 Jul 2012, 08:29

Did not find it directly but still think this http://www.dcbase.org/forum/viewtopic.p ... lit=STA+RD should be concidert, it would make that STA and QUI logic

Post by **Pretorian** » 31 Jan 2013, 19:10

This is in ADC 1.0.2, closing.

DCBase

[ADC 1.0.2] Explicit note about responsibility in STA

[ADC 1.0.2] Explicit note about responsibility in STA

Re: Explicit note about responsibility in STA

Re: Explicit note about responsibility in STA

Re: [ADC 1.0.2] Explicit note about responsibility in STA